Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
![BSI: Insta-cure (2oz)(103) BSI: Insta-cure (2oz)(103)](https://cdn11.bigcommerce.com/s-6k3asdl2tq/images/stencil/500x659/products/7341/26113/bsi103__56784.1721777331.jpg?c=1)
Bob Smith Industries
BSI: Insta-cure (2oz)(103)
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together...
![BSI: Insta-cure+ (1/2oz)(106) BSI: Insta-cure+ (1/2oz)(106)](https://cdn11.bigcommerce.com/s-6k3asdl2tq/images/stencil/500x659/products/7346/22688/download--2-__90196.1716919308.jpg?c=1)
Bob Smith Industries
BSI: Insta-cure+ (1/2oz)(106)
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together...
![BSI: Insta-cure (1/2oz)(101) BSI: Insta-cure (1/2oz)(101)](https://cdn11.bigcommerce.com/s-6k3asdl2tq/images/stencil/500x659/products/7338/24017/s-l1600--1-__85552.1720542077.jpg?c=1)
Bob Smith Industries
BSI: Insta-cure (1/2oz)(101)
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together...
![BSI: Maxi-cure (2oz)(113) BSI: Maxi-cure (2oz)(113)](https://cdn11.bigcommerce.com/s-6k3asdl2tq/images/stencil/500x659/products/7336/26117/bsi113__82392.1721777908.jpg?c=1)
Bob Smith Industries
BSI: Maxi-cure (2oz)(113)
Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty...
![BSI: Insta-Set pump (2oz)(151) BSI: Insta-Set pump (2oz)(151)](https://cdn11.bigcommerce.com/s-6k3asdl2tq/images/stencil/500x659/products/7532/26115/bsi151__38178.1721777803.jpg?c=1)
Bob Smith Industries
BSI: Insta-Set pump (2oz)(151)
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is...