UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.
Bob Smith Industries
BSI: Insta-cure+ (2oz)(108)
$11.99
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together...
Add to Cart
The item has been added
Add to Cart
The item has been added
Bob Smith Industries
BSI: Insta-cure (2oz)(103)
$11.99
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together...
Add to Cart
The item has been added
Add to Cart
The item has been added
Bob Smith Industries
BSI: Maxi-cure (2oz)(113)
$11.99
Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty...
Add to Cart
The item has been added
Add to Cart
The item has been added
Bob Smith Industries
BSI: Insta-Set pump (2oz)(151)
$6.99
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is...
Add to Cart
The item has been added
Add to Cart
The item has been added
Bob Smith Industries
BSI: Insta-cure+ (1/2oz)(106)
$4.79
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together...
Add to Cart
The item has been added
Add to Cart
The item has been added